A brief analysis of the use of Shanghai Bilang electric water heater.
Users of electric water heaters that do not turn off the power of the water heater all the time should always check whether the water heater is normal, and send it to the maintenance point for repair in case of abnormal conditions. Under normal conditions of the water heater, replace the thermostat and heater at the designated maintenance point every 3 years. The liner is cleaned once every six months. The cleaning method is to first cut off the power, close the inlet valve, and then open the outlet valve, turn the drain switch on the safety valve counterclockwise by 90 degrees to naturally drain the water and sediment in the water heater, and then Rinse with tap water. After cleaning, return the drain switch to its original position. Pay attention to that the water can be electrified. If the amount of water in the shower is reduced, it is necessary to clean up the clogged debris in time to ensure the smooth flow of the outlet, which is helpful to extend the service life of the water heater. The installation and use of Lianer instant electric water heater products are incorrect, resulting in the product not working properly. Consumers misunderstand the quality of the product itself.
No water mixing valve is needed. The quick-heating electric water heater does not need to use a water mixing valve, because if the water mixing valve is used in the middle, cold and hot water will flow out at the same time. At this time, the flow of hot water will become smaller, resulting in the water temperature of the water heater. If it is too high, there will be over-temperature (thermostat action), and the phenomenon of water cooling and heating will appear. Customer service personnel should inform the customers who use the mixing valve to turn on the hot water end directly without mixing the cold water. The product has a longer service life and is less prone to scaling.
To control the water flow, the manufacturer must use a special shower equipped with the water heater when installing the water heater. Under normal working conditions, the water heater can adjust the water flow or add a high-grade to increase the water temperature. However, the average user does not have the habit of controlling the flow of the faucet, resulting in the water temperature not reaching Predetermined effect
To install the filter, the quick-heating water heater must install the filter at the water inlet, because there is a small amount of debris in the tap water, so as not to get stuck in the floating magnet (dry burning, not heating) or block the shower (the water is getting smaller and smaller). If the filter is clogged, the flow rate will be reduced, the effluent will be smaller, and the water heater will not be heated if the floatation is not activated. After using it for a period of time, remove the filter to clean it and you can use it.
Check the position of "floating magnet". When installing the water heater, customer service personnel must remember to check whether the "floating magnet" is at the lower end and make it in a free state to ensure the normal use of the water heater. Because the floating magnet is the hydroelectric linkage switch, open the water valve Automatic heating, turn off the water and stop heating. If the debris gets stuck in the floating magnet, the water heater will appear dry or not heated. Remove the debris on the floating magnet to work properly.
BILON brand, dedicated service
Being able to jump higher can be a great benefit in any athletic contest. Improving your vertical leap will help you perform better in basketball and volleyball. It can also help you in football, baseball and soccer. Doing exercises with a Resistance Band can help you improve your ability to jump higher. You need no equipment, other than the resistance band, to do these exercises.
Rubber Resistance Band,Rubber Stretching Bands,Rubber Band Workout,Rubber Resistance Loop Band
Shandong Shangkun Sports Health Technology Co.,Ltd. , http://www.shangkunsports.com